Torque seting of the Torque Limiter s achieved by tightening or loosening the adjustment bolts and/or the adjustment nuts. For torque add itonustment of CTL200 to CTL350,an adjustment nut is provided, an for CTL500 to CTL20 adjustment bolts are provided.

The torque setting can be made after mounting the Torque Limiter on the shaft:

FIirst, rotate the adiustment nut tightly by hand so that the disc spring fits the plate.Then tentatively tighten the nut by about 60 degrees with awrench.

Rotate the nut for fixing the disc spring to the plate, and then fighten each adjustment blot by about 60 degrees.Then, f the Torque Limiter slips under normal loading conditons,tighten the nusfor CTL200 to CTL350) or the bolts (for CTL500or CTL20) gradually until the torquelimiter stops slipping. Aways tighten (or loosen) the bolts equaly try this adjustment several times to find the proper torque setting for themachine For your guidance , the chart on the next page shows the relation between the effective rotated angle and preset torque. FOPprecise torque setting run-n of torque imiter is recommended for example, 500 revolutions at 50 to 60r/min wilth a rotated angle of 45 degrees of adjustment nuts or the bolts.